Our heat cable has an output of 2¾ watts per foot. One cable will give good performance to about 20°. Two cables installed in the same pipe will give protection to about 0°. If two cables are required for your climate, install two cables, putting one on a Thermocube and operating the other manually. This prevents both cables from coming on at the first drop in temperature, thus saving electricity. This is the cable we used in our rabbitry and has been installed throughout the nation with good results. Operates on 110 volts. See diagrams above for installation suggestions.
Caution: Heat cables can NOT be spliced or cut! Please read entire instruction sheet and wiring diagram sent with each cable.
Note:Male plug end not included.
- Prop 65 Warning:
- CALIFORNIA PROPOSITION 65 WARNING: THIS PRODUCT CONTAINS CHEMICALS KNOWN TO THE STATE OF CALIFORNIA TO CAUSE CANCER, AND BIRTH DEFECTS OR OTHER REPRODUCTIVE HARM.