|
Part One: WATER MOTOR
* Has no sliding piston to wear out.
* Is not affected by chemicals since they are injected directly into the water line for mixing.
The HN55 Water Motor is now so advanced, we have less than 1% return on warranty claims. Many of these units have been in the field for six years without service problems
Part Two: CHEMICAL PUMP
* Twists in and out of water motor.
*Easy Maintenance.
|
Specifications:
Water Flow...1 gph to 700 gph
Pressure.........2 psi to 80 psi
Max temp......110 degrees F
Pipe size.........3/4” NHT
Ratio...............1 oz. to 1 gal.
Size.................11” high x 8 1/2” wide
Weight.............6.75 lbs.
No. DTM - 7 lbs. - $255.00 |
Heat Cable 
Our heat cable has an output of 2 watts per foot. One cable will give good performance to about 20. Two cables installed in the same pipe will give protection to about 0. If two cables are required for your climate, install two cables, putting one on a Thermocube and operating the other manually. This prevents both cables from coming on at the first drop in temperature, thus saving electricity. This is the cable we used in our rabbitry and has been installed throughout the nation with good results. Operates on 110 volts. See diagrams on previous page for installation suggestions.
CAUTION: Heat cables can NOT be spliced or cut! Please read entire instruction sheet and wiring diagram sent with each cable. |
|
| Cat. No. |
Length |
Watts |
Amps |
Price |
Qty |
Order |
Compression Fittings
For routing heat cable through water lines in a closed pressure system. Includes two-part brass body, cotton packing and instructions. For low pressure only (1-10psi max.) No. CF - $ 1.35
New shipping rates -- Click Here -- for details!
 * 
|
|