|
 Now everything you need for that new rabbit is in one kit! This all metal cage comes standard with the Kwik-Build option, which allows you to assemble without tools. Specially designed cage is made to accept the dropping pan without the need for a Stack-A-Hutch Kit. Cage size is 24x24 with the overall height of 18" and actual cage inside height of 16". The pan is constructed of 26 gauge galvanized steel with smooth, rolled edges. Also included is our 3 1/2" standard solid bottom feeder and a 32oz Bass water bottle.
No. 1A-SK
$49.95
| Cat. No. |
Size |
Cap. |
Price |
Order |
| 1A-SK |
24x24x18" |
1 |
$ 49.95 |
|
|
|
|
Due to volume of cage orders, some cages may take 7 days to ship. 
|
|
|
Our Cages are constructed with 1" x 2" 14 gauge wire tops and sides, and 1/2" x 1" 16 gauge floors. This is high quality, galvanized before welded, wire. Galvanized after welded wire is much higher in price and does not have the smooth finish that galvanized before has, making sanitation and cleaning much more difficult. However, galvanized after welded wire is available on request. Call for prices.
All Cages are complete with doors installed, door hanger (if applicable), floor spreader(36" and wider cage compartments only), and J-Clips required for assembly. J-Clip pliers are not included in cage price and should be ordered separately for ease of assembly.
WHEN ORDERING Cages, PLEASE NOTE THE FOLLOWING: Only Cages No. 5B thru 8A must be shipped motor freight, see note below. Note: The first number in the size is the side the door is on and the second number is the depth.
**Cages marked with an asterisk must be shipped by motor freight. On all orders that must be shipped via motor freight due to size limits, a minimum charge of $95.00 applies to the first $950.00 of merchandise ordered. Orders that total more than $950.00 will be charged a flat rate of 10% of the order total for shipping and handling.
Note: The first number in the size is the side the door is on and the second number is the depth.
The following Cages have been designed with the smaller mini and dwarf breeds in mind. These Cages can be stacked up to 4 units high using our NEW 14" Stack-A-Cage Kits found on page 2. Cages are 2 or 3 compartment with doors that swing out and use our No.SPL-3 lock. Door openings are 8" x 10". Dividers are1/2 "x 1" mesh wire between compartments with 1" x 2" sides and tops and 1/2" x 1" mesh floors.
Note: The first number in the size is the side the door is on and the second number is the depth.
Available in both galvanized and plastic, all dividers are made to install over the wire dividers when assembling the cage. They are not made to replace the divider that comes standard with the cage. All dividers are punched around the perimeter of the sheet to allow attachment to the wire with c-rings, which are included with the dividers. # CRP C-Ring pliers make installation easier and can be ordered separately.
When ordering dividers, state cage size you will be installing them in. All sizes are the same price. Average ship weight: 3 lbs.
14" - 18" High Dividers
24" - 30" High Dividers
|
New shipping rates -- Click Here -- for details!
 * 
|
|